Subject: RE: tool for output shaft nut?
Author: Jesse Open
Date: May 16, 2003, 3:18 PM
Post ID: 1713026523
Sam ,stop by . You can use mine as long as you need it. I will make one
for you if you pick up a 27 MM deep socket. That socket will make both
the 4 prong wrench and the out put wrench .
Swing by some time.
I will be at the Eurocycle grand opening tomorrow . Are you coming ?
sam heath wrote:
i am replacing the output shaft seal and could use some advice as to what tool can be improvised or if i could buy a tool(hopefully not $$) to remove the nut. also,what should i use to hold the shaft from turning with out @#$%^ up the splines? any advice,comments,dirty pictures etc... are appreciated. sam 70 ambo(leaking) __________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com |