Subject: RE: BOTH CYLINDERS FIRING!!!.............BUT......
Author: Jesse Open
Date: Apr 6, 2003, 2:29 PM
Post ID: 1712526522
Also check the start (choke) plunger on that side. If it fails to seat
it can cause idle problems AND cylinder dropouts.
Patrick Hayes wrote:
| In a message dated 04/06/2003 11:03:05 AM Pacific Daylight Time, 3haw-@bluefrog.biz writes:
It is PAT, but no problem. How carefully did you check the section about examining the throttle cables? Pull on the throttle cable outer housing at the top of the carburetor. At throttle off idle position, there MUST BE a minimum of 1/16" of freeplay in the outer cable. This verifies that your slide has actually reached the idle stop at the bottom. I really suspect your cable is too tight and the carb slide is hanging off the end of the cable instead of resting on the tip of the larger, exposed, knurled idle speed screw. If the cable is loose, then maybe something inside the carb body is holding the slide up. Also possible that you have the slide installed backwards in the carb body? Remember, the smaller, recessed screw controls the air/fuel ratio at idle speed. Won't make much difference at all if the carb slide is being held open and the bike is running above idle speed. Patrick Hayes Fremont CA |