Subject: RE: Rear brake lever circlip
Author: stephen brenton
Date: Nov 18, 2002, 10:01 AM
Post ID: 1711417698
Bruce Giller wrote:
I lost the circlip that holds the rear brake lever from sliding out it's holes on my '72 Eldo (had to bungee cord the lever to stay in place). I believe that the circlip that was on it was of standard dimensions for it was always a bit loose. I measured the OD of the circlip groove to be 13.4 mm. Should I use a 13 mm circlip as a replacement? Or is this a special circlip? |
Bruce-
This isn't the answer you were looking for but, IMHO, remove the rod,
drill it for a small cotter pin and never worry about it again.
-s.