Subject: Preparing a rear drive for service
Author: Fred Sahms
Date: Sep 13, 2002, 11:33 AM
Post ID: 1711005721
Hi all,
I am getting closer to actually needing the rear drive for my Eldo, and
I wonder what you think would be the right way to get it ready for
service. It's been off the bike for several years, sitting on the
shelf. The insides look and feel fine.
I was hoping I could just change the big seal (and maybe the small
internal one), flush out the insides, clean up the outside and use new
gaskets on the sump, etc.
Or would you all recommend pulling off the drive plate, using new
gaskets there, etc.?
TIA
73 Eldo (motor finally together)
78 T3/949