Topica Loopframe_Guzzi Archive


Subject: Fuel Petcock Problem

Author: John Prusnek

Date: Jun 5, 2002, 9:45 PM

Post ID: 1710383423


Keith:
Just a stab in the dark here, but there's a little vent hole in the
top of each of your carbs to allow air to escape, and therefore allow
fuel to flow into your bowls. If the vent hole is blocked, it may cause
the problems you are experiencing. Let us know if this is it.

John Prusnek

 Date: Wed, 5 Jun 2002 13:48:46 +0000
From: Keith Ruff <klru-@fcc.net>
Subject: RE: Fuel Petcock Problem


Good points, I'll go buy some extra fuel line and test each petcock
individually to see if they are working. There is gas in the lower
lines (below the "T" from the left/right fuel lines), so the bowls are
probably full. The upper halves of the fuel lines were dry (above the T
going to each petcock) and that is where the fuel refused to flow into
when opening the petcocks, wasn't until after I loosened the hose clamp
that air escaped and the fuel flooded in and backed up out of the hose
by the clamp. I just wonder with the clamp tightened up again if air
will not go back up into the tank and she will run dry again.

Keith Ruff

Entire thread: