Subject: Re: Used Eldo clutch plates
Author: Bruce Giller
Date: Feb 6, 2002, 11:39 AM
Post ID: 1709579485
The reason why I'm going with the 4 mm System, is that my 2 mm hub has
two notches chewed in to it which made for some tricky clutch work when
things didn't slide right. I guess that you could file out the notches
but that would make for a thin spline.
With my stout-bathed brain, I can't remember if they are spoked or not.
I'm inclined to say that they are not but I'll check them tonight.
Bruce
'72 Eldo
John Boettcher wrote:
Do you have the 2mm input hub too?
Are they "spoked" or not?
JBSince I've 'upgraded' from the original 2 mm clutch to 4 mm, I have two
little used 2 mm bonded clutch plates that are taking up space in my
garage. I'd like to find them a new home for I have a very small
garage...
I got these from Moto International and put about 3000 miles on them.
They are about 7.7 mm thick - for comparison, my new ones from MG Cycle
measure at 7.8 mm. $30 for both.
Bruce
'72 Eldo
JB (Weld)
73 Eldo
71 Ambo