Subject: Re: Forks and front end
Author: Dave Otis
Date: Dec 11, 2000, 12:31 PM
Post ID: 1704404493
There is an exploded view on the lopframe site
http://www.loopframe.com/images/V700/plate12.jpg
At 12:03 PM 12/11/00 -0800, you wrote:
| /=-=-=-=-Click Here & Support Our Sponsor-=-=-=-=-=-=-=-=-= Dial 800-555-TELL for FREE long-distance calls. Tell your friends -- forward this message! http://click.topica.com/aaaa2wb1dfltb1mSiJa/Tellme =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=/ My head bearing is not smooth, has kind of a notchy feeling. I assume it needs to be replaced. I want to tackle it myself but I like to work from some info/ experience/ drawings etc, so I dont screw anything up when I dig into it. I have the shop manual and Guzziology and the Tips book from MGNOC but they dont give much detail about the front end. I did see in the Tips book, a diagram of a tool to pull the fork tubes back up during re-assembly. I'm going to make one of those. Is there a exploded veiw or a diagram of the front end anywhere on the web scanned in? I especailly want to know where the seals are so I dont damage them. Any tips or suggestions how to get the bearings off and then new pressed on? Thanks a lot Pete 71 ambassador ___________________________________________________________ T O P I C Ahttp://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics |
Middletown MD
http://www.loopframe.com