Subject: RE: header pipe adapters for T3 heads

I replied prior to reading Charlie's/your posts. I said OEM...well I
assumed they were - maybe not! All I know is they were in with the
parts bike I bought, and I used them with no problems.

Good Luck!
joe jump wrote:

Yes Greg, 2 pieces, like a 1.5 inch long piece of tubing split
lengthwise to make two pieces.

Greg Bender wrote:

Hi Joe,

Thanks for the information. One question for clarification: For the
pieces that fit between the header pipe flange and the collar that gets
bolted to the head, were they of the two piece split collar type?

joe jump wrote:

Greg,
All I did was grind off the short spigot on the Loop header so
the flange was flat, then used the standard parts for the T/T3 pipes
that fit between the flange (on the header) and the exhaust collar (that

gets bolted to the head). OEM parts.

Greg Bender wrote:

I'm going to be mounting a set of T3 heads on my Ambo...but still use
the loop header pipes with just the end chopped off. I know others on
this list have done this. What size pipe did you find/use to fit the
diameter of the header pipe properly?

Regards,

Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender

Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc

Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc

Joe in St Louis
850T-Powered Ambo
"Junkyard"

Regards,

Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender

Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc

Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc

Joe in St Louis
850T-Powered Ambo
"Junkyard"

Subject: RE: header pipe adapters for T3 heads

Author: joe jump

Date: Aug 31, 2005, 8:37 AM

Post ID: 1719370664

Entire thread: