| |
thanks for the quick replies guys!
scott
Greg Bender wrote:
| |
Hi Scott,
Yes, you need a seal on both bearings - is the same for all drum brake
loops (I think 850T and V7sport models are different):
32 x 48 x 7
As for the rear wheel brakes, do you mean that the shoes are rubbing? If
so, start by comparing the arc and the touch points to the original ones
you are replacing???
That's all the help I can provide from Tampa - good luck!
scott grupe wrote:
| |
Im finally getting the '74 LAPD back together whilst the family is on
summer vacation in the Philippines.....(don't worry I'll get to go out
and play too on the 4th for 10 days).
Im putting real wheel on....
Question: is there a seal goes on either wheel bearing? I show one in
parts schematic but cannot remember. Seems it would have to have a
center hole only as large as axle and I dont have one or did not buy one
last year when I was collecting new parts.
Also, rear brakes fitting into wheel very tight. Everything appears to
be compressed fully.
Also, I need 4 hands and only have 2. Anyone near Norther Virgina wants
to give a hand? Free beer and hamburgers! Maybe a steak if your
good:)Nice area to ride to, near Middleburg.
thnx
scott |
Regards,
Greg Bender
1971 Ambassador
2000 Quota
http://www.thisoldtractor.com/gtbender
Florida MGNOC website
http://www.thisoldtractor.com/fl_mgnoc
Minnesota MGNOC website
http://www.thisoldtractor.com/mn_mgnoc |
|