Subject: Re: Eldo Rear Crank Seal Leak
Author: GUZZI-@aol.com
Date: Mar 14, 2005, 5:37 PM
Post ID: 1718544182
Did you use the GUZZI,brown double lip seal with the directional lines? did
you pull rear main bearing and replace paper gasket,did you jb weld cam plug?
did you replace paper gasket on breather tube?did you replace aluminum washers
on return tube,if no to ANY of those,look there,I allways sand crank seal
surfice with 400 wet with wd 40,then go over it again with 600,if there is still a
little groove.install seal flush with bearing,,,,,,,from the factory,and the
correct way is inboard a little,by going flush.you will be away from the
groove,Mark