Subject: Re: Lucas Reflectors
Author: paul-@comcast.net
Date: Feb 24, 2005, 5:41 PM
Post ID: 1718450962
--NextPart_Webmail_9m3u9jl4l_17914_1109295695_0
Content-Type: text/plain
Content-Transfer-Encoding: 8bit
The reflector and chrome ring go on after you have tightened the bolt. So dissasemble the reflector first. There should be a big fender washer on the inside that the bolt goes thru then thru the rubber then thru the fender. Tighten it all up then place the reflector in the rubber then press the chrome ring on the entire thing.
Paul
-------------- Original message --------------
| Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- 2-Day Tax Refund Loans TaxBrain Online Tax Service Get Started Now! http://click.topica.com/caac8vhb1dfltb6GIoLa/TaxBrain ------------------------------------------------------------------- OK I am stupid on this one. I'm trying to mount some clean used Lucas relectors onto my newly repainted front fender and can't figure out how to tighten them onto the fender. The bolt that runs through the rubber backing then through the fender is not locked, but spins as I am trying to tighten the nut onto it. I've got the nuts started but can't tighten them down because I can't get hold of the bolt to hold it still. Has anybody else gone through this dilemma and know how to get these reflectors on tight? I'm sure I will be going through the same thing when the rear fender arrives. Thanx for any help/advice. Keith Ruff 70 Cafe Racer Ambo Manahawkin, NJ Your free subscription is supported by today's sponsor: ------------------------------------------------------------------- Show your pride with a free* USA T-shirt. Click here to confirm your address. http://click.topica.com/caadc70b1dfltb6GIoLf/PermissionData ------------------------------------------------------------------- |
Content-Type: text/html
Content-Transfer-Encoding: 8bit
<html><body>
<DIV>The reflector and chrome ring go on after you have tightened the bolt. So dissasemble the reflector first. There should be a big fender washer on the inside that the bolt goes thru then thru the rubber then thru the fender. Tighten it all up then place the reflector in the rubber then press the chrome ring on the entire thing.</DIV>
<DIV> </DIV>
<DIV>Paul</DIV>
<DIV> </DIV>
--NextPart_Webmail_9m3u9jl4l_17914_1109295695_0--