Subject: RE: speedo ball
Author: Charlie Mullendore
Date: Feb 9, 2005, 4:02 PM
Post ID: 1718363622
Hi Rob,
There's one spline on the trans. output shaft that is cut further
towards the bearing than the others. And the "worm" drive gear that goes
on the output shaft has a semi-circular hole in it. The ball gets
trapped between the two. I turn the long spline up, tilt the rear of the
trans. slightly up and carefully place the ball in the spline. Then
slide the worm gear on with the hole facing forward. Cheers,
Rob Prins wrote:
So I think I got the tricky parts of the tranny reassembled correctly,
but I'm not sure where to put the speedo ball. My guess is it goes in
the small well that holds the end of the speedometer drive(?) can anyone
confirm or deny this for me?
Thanks,
Rob
Charlie
http://www.loopframeguzzi.com/