Subject: Re: eldo dash wiring help needed- idiot lights?
Author: Tom Halchuk
Date: Feb 8, 2005, 9:09 PM
Post ID: 1718358228
Paul
What are you doing up?
Tom
----- Original Message -----
From: "Custom Guzzi" <paul-@comcast.net>
To: <Loopfram-@topica.com>
Sent: Wednesday, February 09, 2005 12:04 AM
Subject: RE: eldo dash wiring help needed- idiot lights?
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Would You Like Your Money 2-Day? Get started now! TaxBrain Online.
http://click.topica.com/caac8vpb1dfltb7hDhIa/TaxBrain
-------------------------------------------------------------------
Ok, here goes.
Neutral light - green wire from switch
Oil pressure light - gray wire from oil pressure unit
Generator light - red wire from generator
Jumper (white/black) from the neutral light to the oil pressure light to the
generator light to the fuse panel. These are your power wires.
Lights indicator - as you have it. Case of light grounds to frame.
Paul
73 Eldo "Elvira" 949 conversion
74 Eldo "Daisy" undergoing a full police restoration
-----Original Message-----
From: brian c [mailto:bcoo-@creedon.com]
Sent: Tuesday, February 08, 2005 11:36 PM
To: Loopfram-@topica.com
Subject: eldo dash wiring help needed- idiot lights?
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Like music? Get a CD player on us. Click here.
http://click.topica.com/caac8ucb1dfltb6GIoLa/PermissionData
-------------------------------------------------------------------
I don't know if I can link photos here, but I am going to try- at any
rate, I am re-wiring this bike, a 73 eldo with dual dash, and I have not
done one of these in a while and i can't figure it out from my wiring
diagram- I have 4 idiot lights, two of them on the left side have two
spade connectors each and the other 2 have a single female connector
each-
2 spade connectors:
Neutral - has green wire from neutral switch on one and a short wire
going to the oil pressure spade connector on the other.
Oil Pressure- has grey wire from oil pressure sending unit on one and
the shore wire to neutral indicator on the other
Female connectors:
Generator- has on red wire coming from the generator
lights indicator- has one yellow/black wire from light circuit
now, from my wiring diagram for this bike it looks like there should be
a white/black wire coming from the fuse block to the generator light as
well- is this correct, and if so, how am I sopposed to connect it? It
also loks liek there should be a wire connecting the generator light to
the oil pressure light- if so, how do I connect it? just splice it in?
http://pg.photos.yahoo.com/ph/wfrwasher/detail?.dir=/f924&.dnm=fba9.jpg&.src
=ph
http://pg.photos.yahoo.com/ph/wfrwasher/detail?.dir=/f924&.dnm=784e.jpg&.src
=ph
Berkeley, CA
'73 Eldo
74 eldo
73 v7sport
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
We have the 42 Inch Plasma TV you've been looking for!! Sony or
Panasonic 42 Inch Plasma Wide Screen TV's. Put one up on your
wall today! Click Below
http://click.topica.com/caac8uBb1dfltb6GIoLf/ExclusiveRewards
-------------------------------------------------------------------
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Need a Laptop? Get a Sony Vaio Laptop Free!
http://click.topica.com/caac8usb1dfltb7hDhIf/ProductTestPanel
-------------------------------------------------------------------