Subject: RE: Head Gasket
Author: Paul P. Linn
Date: Jan 16, 2005, 1:33 PM
Post ID: 1718219928
That head gasket refers to the later motor like a T3. Their pushrods were
moved further away from the cylinders to allow for larger displacements like
the V1000. If you used the stock Eldorado head gasket on a T3, the pushrods
would rub against the gasket and wear them down.
Paul
73 Eldo "Elvira"
74 Eldo "Daisy" undergoing a full police restoration
-----Original Message-----
From: Gunnar Schwede [mailto:gs_-@yahoo.com]
Sent: Sunday, January 16, 2005 4:26 PM
To: Loopfram-@topica.com
Subject: Head Gasket
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Like music? Get a CD player on us. Click here.
http://click.topica.com/caac2NUb1dfltb6GIoLa/PermissionData
-------------------------------------------------------------------
Do I need to use the 'new type' gasket for cylinders using oval push rod
tubes, for these cylinders? When I pulled the cylinders apart they had
the regular head gaskets with the round pushrod holes..
http://www.hawgflatts.com/Forum/guzzi_disassemble%20004.jpg
Gunnar
http://www.72guzzi.2ya.com/
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Show your pride with a free* USA T-shirt. Click here to confirm
your address.http://click.topica.com/caac2N5b1dfltb6GIoLf/PermissionData
-------------------------------------------------------------------