Subject: Re: Breva motor in a loop frame
Author: paul-@comcast.net
Date: Jan 11, 2005, 1:25 PM
Post ID: 1718191953
--NextPart_Webmail_9m3u9jl4l_16057_1105478700_0
Content-Type: text/plain
Content-Transfer-Encoding: 8bit
I'm sure you could change out the front cover for a Loop one. If not, a little creativity with the welder and some new mounts will magically appear on the frame. Bet Mark could mount one of these in a few hours. Use a Eldo 5 speed and your all set.
Paul
-------------- Original message --------------
Your free subscription is supported by today's sponsor:--NextPart_Webmail_9m3u9jl4l_16057_1105478700_0
-------------------------------------------------------------------
Race to claim your complimentary Chevy collectible!
http://click.topica.com/caac2NWb1dfltb6GIoLa/PermissionData
-------------------------------------------------------------------
the motor mounts at the top rear of the trans and midway up the timing chest
in front.
I agree with Tom.
be fun to try, tho
Matt
----- Original Message -----
From: "tom short"
To:
Sent: Tuesday, January 11, 2005 2:48 PM
Subject: Breva motor in a loop frame
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
How about a cruise on your favorite cruise line-from us? Click
here.
http://click.topica.com/caac2NYb1dfltbOfdmla/PermissionData
-------------------------------------------------------------------
It would be easier to put loop parts onto that frame, than to put that
motor into a loop frame, me thinks!
The Arizona Kid
LFL 009
Tom Short
AZ MGNOC Rep
Phoenix, AZ
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Click here and get your free* stock car racing gift.
http://click.topica.com/caac2NQb1dfltbOfdmlf/PermissionData
-------------------------------------------------------------------
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
** Get Your Own Support-a-Cure Yellow Bracelet for $1.99 **
Show your support for finding cures for both AIDS & Cancer.
Get yours for just $1.99. This bracelet makes a difference.
http://click.topica.com/caacYkkb1dfltb6GIoLf/PennMedia
-------------------------------------------------------------------
Content-Type: text/html
Content-Transfer-Encoding: 8bit
<html><body>
<DIV> </DIV>
<DIV>I'm sure you could change out the front cover for a Loop one. If not, a little creativity with the welder and some new mounts will magically appear on the frame. Bet Mark could mount one of these in a few hours. Use a Eldo 5 speed and your all set.</DIV>
<DIV> </DIV>
<DIV>Paul</DIV>
--NextPart_Webmail_9m3u9jl4l_16057_1105478700_0--