Subject: RE: shims/misc.
Author: Charlie Mullendore
Date: Oct 21, 2004, 2:53 PM
Post ID: 1717741553
Hi Steve,
Have the points screw for you. Where should I send it? Reply off-list to
Amboman4 @ netscape.net. Cheers,
STEVE FARRIS wrote:
| charlie one screw would be nice, the eldo looks good. if the part # for the shims is handy then go ahead and let me know if not, I'll look it up on the link you sent me, can't be too difficult. do you think these need to be any special material i.e. stainless, carbon, hardened, plated, or just plain steel? since there were none in my wheel approximately what thickness would I be looking for? Steve |
Charlie
http://www.loopframeguzzi.com/