| |
I don't know. Manufacturing tolerances? A misaligned jig for drilling
the positioning dowels? Bob fixed many of them by pulling out the
dowels and redrilling them while fixtured in his jig.
GF
On Tuesday, September 14, 2004, at 02:58 PM, Ray Hale wrote:
| | Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
http://click.topica.com/caacBBBb1dfltb6KFeCa/MyDietPatches
-------------------------------------------------------------------
And what would be the cause of a bad alignment here? Sounds serious
Ray
Greg Field wrote:
| |
It measured alignment between the tranny input shaft and the
centerline
of the crankshaft.
GF
| | Ray
My understanding of Nolan's jig was not to look for bent shafts, but
to look
at over all, how the gear box fits to the engine.
Ken
Asheville, NC
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Sponsor a child today through Children International.
Give a desperately poor child hope for a brighter future.
For only $18 a month you can make a difference!
http://click.topica.com/caacBBFb1dfltb6KFeCf/ChildrenInternational
------------------------------------------------------------------- |
|
Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Do you live vicariously through Reality TV? Let us know and win!
http://click.topica.com/caacDv1b1dfltb6KFeCf/PermissionData
------------------------------------------------------------------- |
|