Subject: RE: Wheel bearing race tool tip
Author: Custom Guzzi
Date: Apr 3, 2004, 6:50 AM
Post ID: 1716466872
Scott,
The welds are on top. Your dash will cover them. I've never had a lock
washer on any of my bikes.
Paul
Midlothian, Va
MGNOC#19926
73 Eldo "Elvira" next project
74 Eldo "Daisy"
scott grupe wrote:
Once a VeeDubber always a VeeDubber. I was just installing new bearings in the front end last nite. Uded one of my BIG metric ones but never paid attention to the size... I got a question for u. Im putting the front end back on after getting the triple tree and upper plate powder coated. I cant remember if the top plate goes on with welds exposed up or down. I believe its up from crummy manual pix. but then my lock washer under the center yoke shaft hold down does not want to fit in smoothly...unless there is just a bit too much powder coat built up there. thank scott Ray Hale wrote:
|