Topica Loopframe_Guzzi Archive


Subject: Gas in oil

Author: Jason Stallings

Date: Sep 30, 2003, 9:13 PM

Post ID: 1714709537



--0-1204518403-1064981626=:79859
Content-Type: text/plain; charset=us-ascii

Last week I put my bike up and did not turn the gas taps off. A couple of days later I went to ride it and noticed a ton of gas had leaked out of the carbs. I checked the oil before starting the bike and it was the pan full of gas. So I changed the oil out. I have heard this could happen but it seems like I use to be able to leave the gas taps on and not have any problems.

I am also still having problems maintaining an idle and the bike seems to bog down (engine sounds lower and very slowly accelerates - even accelerates better when letting a little throtle off) when accelerating past 60 mph. I have mentioned this before but I have still not taken the carbs apart to see what is going on. I am planning on going through them ASAP, I have the Premier Handbook should this be a good enough guide for a first timer? What parts should I order - just the gasket kit from mgcycle? Any other tips or suggestions would be appreciated.

--0-1204518403-1064981626=:79859
Content-Type: text/html; charset=us-ascii

<DIV>Last week I put my bike up and did not turn the gas taps off. A couple of days later I went to ride it and noticed a ton of gas had leaked out of the carbs. I checked the oil before starting the bike and it was the pan full of gas. So I changed the oil out. I have heard this could happen but it seems like I use to be able to leave the gas taps on and not have any problems. </DIV>
<DIV> </DIV>
<DIV>I am also still having problems maintaining an idle and the bike seems to bog down (engine sounds lower and very slowly accelerates - even accelerates better when letting a little throtle off) when accelerating past 60 mph. I have mentioned this before but I have still not taken the carbs apart to see what is going on. I am planning on going through them ASAP, I have the Premier Handbook should this be a good enough guide for a first timer? What parts should I order - just the gasket kit from mgcycle? Any other tips or suggestions would be appreciated.</DIV>
--0-1204518403-1064981626=:79859--

Entire thread: