Topica Loopframe_Guzzi Archive
 

Subject: Re: swing-arm pivit tool

Author: Paul P. Linn

Date: May 16, 2003, 11:49 AM

Post ID: 1713024069


Just remember to make note of the exact spot the fork lock groove is before
you remove the stem.

Paul
Midlothian, Va
73 Eldo "Elvira" at a halt in favor of "Daisy"
74 Eldo "Daisy" new project
----- Original Message -----
From: "Ray Hale" <ray.-@sfcc.edu>
To: <Loopfram-@topica.com>
Sent: Friday, May 16, 2003 2:30 PM
Subject: RE: swing-arm pivit tool


 I am having the triple tree powder coated and thought it would be better
to remove the stem if possible, to avoid possibilitiy of damage.
Ray


Paul P. Linn wrote:
 
Ray,

Firstly, why do you want to remove it? I believe it is a press fit, but
you
have to remove the nut on the bottom to get it out.

Paul
Midlothian, Va
73 Eldo "Elvira" at a halt in favor of "Daisy"
74 Eldo "Daisy" new project
----- Original Message -----
From: "Ray Hale" <ray.-@sfcc.edu>
To: <Loopfram-@topica.com>
Sent: Thursday, May 15, 2003 9:04 PM
Subject: RE: swing-arm pivit tool


 Tools!! It's all about the tools.
Thanks to all for suggestions on the shocks and swing arm pivot.

Can I impose with yet another question? I'm trying to remove the stem
from the lower triple tree and before I apply the "heat wrench" or the
"big hammer" does this thing press out or screw out? I really do look
in
 
 
 the parts and shop manuals before asking but there is precious little
info at this level of disassembly.

Thanks
Ray

Entire thread: