Subject: RE: swing-arm removal
Author: Arizona Kid
Date: Feb 4, 2003, 11:32 AM
Post ID: 1711873676
Ian Adkins wrote:
| Tom, Once you remove the swing arm pivot spindles the swing arm should just pull straight away from the frame. I removed the rear drive and all of the brake rods etc.. |
Everything is off. I just can't swing the piece out. Pissin' me off!!!!
I had it off before, that is where I did my thickfisted mech. work on
the bike. Hopefully the carrier bearing is as good as the u-joint was!!
Any idea how to clean the pipes???
The 'Arizona Kid'
Tom Short
AZ MGNOC Rep
Phoenix, AZ