Subject: 4 Spd. throwout bearing
Author: P67V7
Date: Nov 19, 2002, 3:09 PM
Post ID: 1711427155
Hello All;
This past spring I replaced the clutch in the V7. I was going to replace the
throwout bearing but after all the talk about maching the case I figured I
would just get new balls. (no pun intended) That was all I needed as my
races and cage were good. OK, I am getting to the point of this... Later I
was talking to a guy at Harpers and I think I remember him telling me that
they have a replacement bearing set-up that you DO NOT have to machine the
case out for.
Also my bearing cage is brass...
Paul
_________________________________________________________________
MSN 8 with e-mail virus protection service: 2 months FREE*
http://join.msn.com/?page=features/virus