Subject: Re: Dual point won't fit in Ambo
Author: Maitrim-@aol.com
Date: Nov 4, 2002, 10:35 AM
Post ID: 1711329214
--part1_20.171c3f1.2af817fa_boundary
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit
In a message dated 11/4/02 12:05:37 PM Eastern Standard Time,
MGcoo-@aol.com writes:
Its been confirmed, although a few said it would, the dual point distributor will not fit in the Ambassador case. This was confirmed by Mark Etheridge, as we chatted on the phone he physically tried to fit the dual point into an Ambassador case...... no go. The tunnel leading to the cam shaft is to small for the distributor base & gear. The case can be bored out but if I go to the trouble of pulling everything out of the case, I could just go with an Eldo case & not have to do the machining. Ken |
Ken, I was informed on the list that you could swap shafts in the
distributors. Anyone know for sure!? Thanks. Mark
--part1_20.171c3f1.2af817fa_boundary
Content-Type: text/html; charset="US-ASCII"
Content-Transfer-Encoding: 7bit
<HTML><FONT FACE=arial,helvetica><FONT SIZE=2>In a message dated 11/4/02 12:05:37 PM Eastern Standard Time, MGcoo-@aol.com writes:
<BR>
<BR>
<BR><BLOCKQUOTE TYPE=CITE style="BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">
<BR>Its been confirmed, although a few said it would, the dual point distributor
<BR>will not fit in the Ambassador case. This was confirmed by Mark Etheridge, as
<BR>we chatted on the phone he physically tried to fit the dual point into an
<BR>Ambassador case...... no go. The tunnel leading to the cam shaft is to small
<BR>for the distributor base & gear. The case can be bored out but if I go to the
<BR>trouble of pulling everything out of the case, I could just go with an Eldo
<BR>case & not have to do the machining.
<BR>
<BR>Ken
<BR>
<BR></BLOCKQUOTE>
<BR>
<BR>Ken, I was informed on the list that you could swap shafts in the distributors. Anyone know for sure!? Thanks. Mark</FONT>
</HTML>
--part1_20.171c3f1.2af817fa_boundary--