Topica Loopframe_Guzzi Archive


Subject: RE Valve adjust question

Author: P67V7

Date: Jul 27, 2002, 5:35 AM

Post ID: 1710681140



Keith; Where do you live in NJ? I am in Delaware not to far away possibly.
Please excuse my rambling if you have already tried this.
First,did you check TDC by looking to see if the piston is near the top and
checking to see if you are on the compression stroke? the distributor rotor
will be pointed towards that side you are adjusting if it is correct or as
cookie mentioned try the finger over the plug hole method.
Second are you using the correct demensions? IE 0.15mm (.059in)for inlet,
0.25mm (.098in)for exhust as per my 850 shop manual.
Call me at 302-792-9080 and we could run through it over the phone.
Unless your sure you have it correct I would not start the engine.
Paul



_________________________________________________________________
Send and receive Hotmail on your mobile device:http://mobile.msn.com

Entire thread: