Subject: Re: distributor gear pin
Author: dave luby
Date: May 8, 2002, 3:33 PM
Post ID: 1710221172
On the peen end of the pin,take a Dremel tool or small grinder and grind the
peen off,not too much and it should drive out with a flat end punch.As for a
replacement, I used a snug fitting slightly tapered pin leaving about 1/8"
over on both ends.Peen the ends down.Make sure the ends don't stick out too
far as it may interfere with the cam gear.70k+ and no problems.
Dave
_________________________________________________________________
Get your FREE download of MSN Explorer athttp://explorer.msn.com/intl.asp.