Subject: RE: Missing stud on flywheel housing...need to know size
Author: stephen brenton
Date: May 6, 2002, 12:21 PM
Post ID: 1710204725
David Szenasy wrote:
| On my Eldo where the transmission attaches up to the flywheel housing, the PO put in bolts instead of the correct threaded stud with nuts and washers. I need to replace two at the very bottom. Any idea what size diameter and length these should be? |
David-
The studs are 8mm. If there is a alignment bushing the stud is 74mm
long, if there is no bushing the stud is 66mm long. Another point, the
studs from my engine had more thread on one end than the other. The
shorter length of thread goes into the engine block. I installed mine
with red loctite.
-stephen in sc.