Subject: RE: Fork Assy. Tool
Author: Zerhackermann
Date: Feb 19, 2002, 5:24 PM
Post ID: 1709679087
It can if the threads on the tool are not seated all the way.
-----Original Message-----
From: Jack Lundberg [mailto:jack-@aol.com]
Sent: Tuesday, February 19, 2002 5:13 PM
To: Loopfram-@topica.com
Subject: Re: Fork Assy. Tool
============================================================
Save up to 80% on Inkjet Cartridges & get FREE Shipping
too! All products 100% GUARANTEED. Easy to find what you
need. Fast shipping.Prices lower than office supply stores.
http://click.topica.com/caaag0Pb1dfltb2c9oVa/myinks.com
============================================================
I made a nifty tool to pull the fork tube thru the triple clamp. I got
a
used fork cap (threads into the fork tube). I filed off the hex so that
it
will pass thru the triple clamp. Then I tapped a 5/8" thread thru the
clamp.
Next I got a length of 5/8" all thread and a couple of nuts. A piece
of
pipe is fit over the 5/8" all thread, held between the 2 nuts, with room
to
slide the pipe up and down, as in impact wrench. Works like a shot and
absolutely cannot damage the threads.
Jack Lundberg
Colorado Springs, CO
'72 Ambassador, '73 Eldo, '86 LeMans 1000,
------------------------------------------------------------
Join "Aiken's Short Laugh A Day" now!
http://www.AikensLaughs.com
More CLEAN laughs than you can imagine -> FREE!