Subject: RE: Fork Assembly Problem
Author: Fred Sahms
Date: Feb 19, 2002, 7:40 AM
Post ID: 1709674412
David Whalen wrote:
| noticed that the interior threaded part of the left fork assembly had "fallen down" into the outer portion of the fork tube thereby making it impossible to refasten that side of the fork assembly to the upper triple plate. The right side was fine, however. Has anyone had this experience who might share some insight. |
lower clamp (are these loosened?) You need the cool special tool to
reach down there, thread into the tube, and yank it back up.
If you didn't loosen the lower clamping bolts, it might be a good time
to check em! I would loodsen them after you have both upper nuts
threaded down but not tight, and then tighten them after tightening the
top nuts.
73 Eldo in crates
78 T3/949