Subject: RE: Fabricating Road Lite Brackets
Author: Tom Bowes
Date: Oct 30, 2001, 6:53 PM
Post ID: 1708750530
Ron,
If you are talking about using the nut on the bottom of the steering
head shaft for mounting purposes, my guess is that you are going to be a
bit short on threads to hold everything together. Now you could make a
plate to fit on the top of the lower triple clamp and then run bolts
through the holes that are in the end of each of clamp's slots.
Ron Bishop wrote:
| How would it be to use a flat piece of metal,cut a slot that would fit into the lower triple tree and one hole that the bolt on the tree could go through? May have to use a longer bolt as I would be using 1/4 inch stainless. Any suggestions? My son works at a place uses water jet & plasma cutters. Also a lot of scrap:} Ron |
Tom
'70 (July '69) Ambassador
'82 V50-III
Shelby Township, Michigan