Subject: Re: Guzzi Question
Author: Zerhackermann .
Date: Jun 25, 2001, 1:26 PM
Post ID: 1707255287
Get a good hardened bolt of the proper diameter. Cut the head off. I believe
2" is the right length. The thread the retaining bolt back in. a couple
turns with the allen wrench and *pop*.
cookie is right in that a soft aluminum or soft steel rod/bold is a bad
idea.
| From: Martin Cooke <cook-@virgin.net> Reply-To: Loopfram-@topica.com To: Loopfram-@topica.com Subject: Re: Guzzi Question Date: Sun, 24 Jun 2001 09:34:30 +0100 long (can't be exact, I can't find mine). Remove bolt from centre of rotor, as you have done, & insert tool. into rotor. Screw bolt into middle of rotor till tight. Tap with hammer. Repeat until Rotor falls off taper. Don't use home made tool lashed up out of mild steel nail or similar. It will bend inside rotor & get stuck & you'll be very sorry. cookie |
Get your FREE download of MSN Explorer athttp://explorer.msn.com